DILLON Quick-Check Tension Meter w/BlueTooth+ Rod +16 Calibrations

Dillon Quick Check-T Tension Meter

-Bluetooth® enabled with a custom mobile app to allow you to automatically record and report on job sites.

The Dillon Quick Check-T tension meter makes a difference. It reduces time on the job site by eliminating the need for whiteboards, changing sheaves, and the need for charts to figure out target tensions. This unit also reduces time off of the job site by having automatic site form completion, with image, and direct complete reports.

This set includes the Quick Check-T, Calibration Check Rod and 16 Tower Wire Calibrations

Key Features:

• Bluetooth® enabled
• Custom mobile app
• Multi-wire single sheave
• Calibration check rod
• Automatic report generation with photos
• Automatic target tension calculations
• Ability to capture pre and post tension readings
• Inbuilt image capture

- Capacity: 10,000 lb/45 kN/4500 kg
- Communications: Bluetooth®
- Data Export: Via mobile app
- Wire Calibrations: Up to 20 wire calibrations
- Capture Rate: 10Hz, 100Hz & 1000Hz
- Accuracy: + 3% instrument capacity
- Operating Range: -4° F to 158° F (-20° C to 70° C)
- Protection: Hard polymer storage case included
- Environmental: Suitable for continued outdoor use
- Weight: 11 lb (5 kg)
- Size: 0 x 23 x 3" (25 x 59 x 8 cm)
- Range: Wire sizes from 3/16" (4.75 mm) up to 1.0" (25.4 mm)
- Display: Dot-graphic LCD display supports full text
- Units of Measure: lbf, kgf & Newtons
- Resolution: Low / med / high (5000 resolutions)
- Battery: Two C batteries
- Calibration: 2 x AA battery's with 120+ hours life (backlight off )
- Calibration: Each wire rope is calibrated and is traceable to the National Institute of Standards and - Technology. Certificate included with curve readings. Passes only with three consecutive confirming runs, with all points in specification.
- Recalibration: Every 12 months
- Approved By Majority of cell tower owners